Thursday , August 17 2017
Home / Trotec

Trotec

July, 2016

  • 3 July

    Changing the Cones on a Trotec Rotary

    In this video we will show you how to reverse the cones on the Trotec rotary attachment so that you can reverse your glass or round item when you are lasering it.

June, 2016

  • 26 June

    Working with The Trotec Rotary Attachment Part 5

    In this tutorial we will look at how to engrave two different logos on a wine glass. Each logo will be located on opposite side of the glass. This can be a hard job set up unless you put a little thought into it. It is easy in the Trotec …

  • 25 June

    Working with The Trotec Rotary Attachment Part 4

    In this lesson we will look at how to create a design on glass that will have two logos one on each side. In our last lesson we looked at how to create a design all the way around a glass. In this lesson we will look at placing an …

  • 25 June

    Working with The Trotec Rotary Attachment Part 3

    Looking at creating a full wrap design on a wine glass? In this tutorial we will be looking at how to create a two logo design on a wine glass. Although this technique may seem hard it is easy if we follow a couple of basic steps. With the Trotec …

  • 25 June

    Working with The Trotec Rotary Attachment Part 2

    In this lesson we will continue on looking at how to set up a rotary job on our Trotec Laser. In this lesson we will give you a quick introduction to the creating a print job that is only the size of the logo. Instead of locating the image in …

  • 22 June

    Working with The Trotec Rotary Attachment Part 1

    This tutorial will show you how to use the Trotec rotary attachment. When it comes to working with the Trotec rotary there are 3 ways to create a job on the rotary. In this tutorial we will go through the first of three ways. In this tutorial we will generate …